Constant Bottom hole pressure operating condition in Eclipse Software

[ibtisam01]

Assalam-o-Alaikum all,

I want to simulate the well performance using 'Constant bottom hole pressure' condition. Through which item in WCONPROD, i can use this condtion? using item 'BHP' in control mode refers to lower limit of bottom hole pressure but i want to use as upper limit.....

any suggestion please............

Jazak Allah khairan

[vinomarky]

Use BHP. As long as you dont have any rate or watercut limits set that would result in it choking back production (and increasing BHFP), then it will try to honor the set pressure