<

Search:

Tag: 25%

Search: Search took 0.00 seconds.

    • Views: --
    Today

    1. Lifting Frames

      Started by avaccess, 03-06-2014 06:15 PM
      100%, 25%, bodies, dies, frame, frames, lifting, opinion, overload, required, suggested, test, testing, unsure 1 Attachment(s)
      • Replies: 1
      • Views: 977
      Last Post: 03-16-2014 03:17 PM
      by miree82  Go to last post

      Forum:
      Mechanical Engineering

    2. Recommended Alloy for High H2S and Co2 corrosion

      Started by Kirwan34, 07-19-2013 08:40 PM
      145°c, 25%, 3500psi, alloy, bottom, co2, conditions, corrosion, downhole, equipment, h2s, hole, maximum, pressure, recommended
      • Replies: 0
      • Views: 955
      Last Post: 07-19-2013 08:40 PM
      by Kirwan34  Go to last post

      Forum:
      Materials Science &Corrosion

    3. Cathodic protection of above ground storage tanks

      Started by f.ghezeljeh, 02-16-2011 09:51 PM
      25%, additional, applicable, centigrade, current, degree, derating, increased, increasing, limit, protection, required, tank, temperature, upper
      • Replies: 1
      • Views: 4,446
      Last Post: 04-02-2011 08:24 AM
      by cytech  Go to last post

      Forum:
      Electrical & Power Engineering

    4. required current density derating due to surface temperature

      Started by f.ghezeljeh, 03-03-2011 12:25 AM
      10, 25%, additional, applicable, cathodic, centigrade, current, derate, derating, due, increament, protection, tank, temp, temperature
      • Replies: 0
      • Views: 1,279
      Last Post: 03-03-2011 12:25 AM
      by f.ghezeljeh  Go to last post

      Forum:
      Materials Science &Corrosion

    5. above ground storage tank bottom protection

      Started by f.ghezeljeh, 02-17-2011 09:17 PM
      25%, additional, applicable, bottom, current, degree, derating, increased, increasing, limit, protection, required, tank, temperature, upper
      • Replies: 0
      • Views: 2,086
      Last Post: 02-17-2011 09:17 PM
      by f.ghezeljeh  Go to last post

      Forum:
      Materials Science &Corrosion

    6. PTFE Gasket 'm' and 'y' value

      Started by mbc.engg, 07-18-2009 12:10 PM
      25%, appreciated, brochure, comments, friends, gasket, gf, including, mark, ptfe, standards, suggestions, types, values 1 Attachment(s)
      • Replies: 4
      • Views: 7,158
      Last Post: 06-29-2010 04:17 AM
      by eriyanto.edy  Go to last post

      Forum:
      Mechanical Engineering

    • Views: --
    Today
    • Views: --
    Today -
    • Results 1 to 6 of 6
    1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40