Designing for Control Valve Pressure Drop

[notachance]

I found a series of excellent articles on considerations for design of control valve pressure drop. The articles are located in the post here:

[link Point to another website Only the registered members can access]


Hope these help you in your work!

[notachance]

For easy reference, the articles links have been copied below:

Here is a link for the article:

[link Point to another website Only the registered members can access]

Here are additional articles on the subject:

[link Point to another website Only the registered members can access]

[link Point to another website Only the registered members can access]

[link Point to another website Only the registered members can access]

[link Point to another website Only the registered members can access]

[link Point to another website Only the registered members can access]


Also be sure to consider effect of noise on minimum valve size:

[link Point to another website Only the registered members can access]

[notachance]

For easy reference, the articles links have been copied below:

Here is a link for the article:

http://www.theseforums.com/c10e052a

Here are additional articles on the subject:

http://www.theseforums.com/2e47f692

http://www.theseforums.com/68c066da

http://www.theseforums.com/4b27e529

http://www.qqc.co/87418ec0

http://www.ultrafiles.net/6e2e2a2c



Also be sure to consider effect of noise on minimum valve size:

http://www.theseforums.com/7b827c8c

[marwanab]

Thanks for these good design guidelines for valve sizing dP

[AliDouceur]

thanks