How to reinject the gas produced from the previous timestep?

[adnanhq]

Hi, this is question to reservoir simulation engineers....

In eclipse simulations, How can we reinject the gas produced from the previous timestep ? I mean to say which key word is used for this purpose?

Hope I have made it clear.

Thanks in advance.

[i-anuar]

play with item 8 of wconinj

(edit)
newer keyword, --> put under group control with wconinje, then in GCONINJE items 3 and 6

[adnanhq]

So, do these two options collectively reinject the gas or any one can be used?

play with item 8 of wconinj

(edit)
newer keyword, --> put under group control with wconinje, then in GCONINJE items 3 and 6

[adnanhq]

So, do these two options collectively reinject the gas or any one can be used?

play with item 8 of wconinj

(edit)
newer keyword, --> put under group control with wconinje, then in GCONINJE items 3 and 6

[Jon. Carter]

Thanks.

[Murat K]

Hi,

Since you're talking about the gas re-injection, my question is following:

I am doing a gas-condensate reservoir case. Do you know what keyword(s) I need to use for gas relative permeabilities in Eclipse? The problem is that when the reservoir pressure drops below the dew point, I have the condensate in pores. Even though it is immobile, but the gas phase permeability is reduced. I was using SWOF and SGOF keywords combination; however, I don't have an active oil and water presence, that's why I am confused.

Thanks in advance.

[Murat K]

Hi,

Since you're talking about the gas re-injection, my question is following:

I am doing a gas-condensate reservoir case. Do you know what keyword(s) I need to use for gas relative permeabilities in Eclipse? The problem is that when the reservoir pressure drops below the dew point, I have the condensate in pores. Even though it is immobile, but the gas phase permeability is reduced. I was using SWOF and SGOF keywords combination; however, I don't have an active oil and water presence, that's why I am confused.

Thanks in advance.