Problem with OLGA 7 tutorial

[usyd12a]

Hi all,

I am working on the tutorials in "FA with OLGA - Exercises" but have been stuck on the very first one. My project is "verified" but I can not make it run (and stop normally). I have tried everything (even comparing genkey files but still could not figure out what's wrong)

Can anyone please help me?

Thank you very much indeed.

usyd12a

[link Point to another website Only the registered members can access]

[sgu]

you have not entered some basic data like DTPLOT, DTMIN, DTMAX etc. also, in segment PIPE-1, the total length of all segments is not equal to X-END. there are small little things that are missing for ex. in TREND and PROFILE under OUTPUT key. If you look at the output file, it gives why the simulation stopped and where the problem was. Hope this helps - if not please ask.

Hey dude, could you please send me this training material by e-mail? I'll be very grateful.

[usyd12a]

Thanks for your reply sgu.

OLGA has not given me any output file so I can't check it. I'll try the rest of your suggestions.

For the training material, please let me have your email

[sgu]

An output file is always created after OLGA is run. You can see the output file from the 'view' menu at the top. (at least in version 5 - I'm sure it is also the case in OLGA 7)

[sgu]

I have sent you a PM with my email address

Regards