Manifold design

[mariosarmiento]

Hello friends, I need help.

I want to know how I can design manifolds, in special its valves (size in inches).

I want to know how I can design outputs control numbers (numbers of outlets).

And I want to know how I can design or know how many Numbers of stations I must have in a Rig.

Thanks so much for your time and your help.

[BOUGHELOUM]

you can look to IADC drilling manual and API RP 53 and API SPEC 16C

[mariosarmiento]

Thanks... so i have the API RP 53, but I don´t know how I send that to this page.

[jovyan]

Hi Mario,
Could you please mail the API RP 53 to me at jovyanrodrigues2004@yahoo.com. Thanking you.

[BOUGHELOUM]

API RP 53

[link Point to another website Only the registered members can access]

[jovyan]

thank you very much for the API Much appreciated. Do u know ur self or know anyone that can guide me using wellplan. Thanks

[BOUGHELOUM]

must install the software then used help or start / landmark / user manual pdf

[jovyan]

I did install the s/w thanks to this site. But there is no step by step sort of guide for operating the software. U can start anywhere and can reach anywhere. Atleast in the begining one should know where one is going. Then at an advanced stage you can explore new methods. Do You know anyone pls

[BOUGHELOUM]

is the maximum that I can help you

[link Point to another website Only the registered members can access]

[jovyan]

thank u very much. ur helping spirit is much apreciated