Paladin Design Base Full and Free

[surgeArrester]

Installation Steps would be:

1- Install “SMAC 2.0” software on your computer. ( I shall also give you the link for this software)
2- Once installed SMAC software, generate its serial from the ----- folder and make this software active.
3- Run this software and change the MAC address of your computer. ( I shall provide you the correct MAC address along with matching .lic file for EDSA).
4- Download the Design Base software and install it on your computer.
5- Then copy the .lic file and paste it under “C:\Design Base5\config
6- Go to start, All Programs, Paladin Design Base, and click on “Rebuild Paladin Design Base Toolbar”.
7- After that you can run the program from the Design Base Icon on Desktop normally.
Here is the link for SMAC software to change the MAC address.

[link Point to another website Only the registered members can access]
Run this software and change the MAC address of your computer as per the following:

2C 76 8A B0 29 62 and click update MAC. The software will change the MAC of your computer. After that restart your computer.

And Install EDSA Paladin Design Base software.

[link Point to another website Only the registered members can access]

[link Point to another website Only the registered members can access]

[link Point to another website Only the registered members can access]

[link Point to another website Only the registered members can access]

[link Point to another website Only the registered members can access]

[link Point to another website Only the registered members can access]
License:

[link Point to another website Only the registered members can access]
Enjoy

in step one, you can also use tmac.. a software to change the mac address.. and it is free..

[link Point to another website Only the registered members can access] tmac/


with this you can change your mac address restore it without computer restarts..