what the keyword i have to use, if i wanna shut in well when the THP reach/under 200 psi? i use e300, i used to use WCONPROD, but after THP reach/under 200 psi, the software change to BHP as control pressure
thanks
Member
what the keyword i have to use, if i wanna shut in well when the THP reach/under 200 psi? i use e300, i used to use WCONPROD, but after THP reach/under 200 psi, the software change to BHP as control pressure
thanks
Very Active Member
Can you paste your WCONPROD line here to check what your current control points and limits are set to?
Last edited by vinomarky; 08-04-2010 at 07:05 AM.
Posting Permissions
Reply With Quote
Bookmarks