how to get pressures and temperatures at the grid points of Eclipse

[cpiano]

Hello everyone,

I'm not a petroleum engineer but I needs to get pressures and temperatures from an Eclipse model in a short period of time. I really appreciate if you guys can give me some advice or even keywords to look for.

I am making a FLAC model for a reservoir. I have a 3D E300 model for the reservoir; it's already run so I have all the outputs.
I need to get the pressures at the grid points of the E300 model and then apply them to my FLAC model. Eventually, I might decide to apply only the maximum pressures to the FLAC model but not sure about it yet. I also need to get the temperatures from Eclipse.

So do you think if it's possible?
or I can only get the pressures along the lines of Eclipse model and not for each single grid point?
If it's possible, can you tell me where/what to look for? Like should I run the PVTi? Or should I open it with Petrel?
We don't have the license for FloGrid buy I have access to Petrel.
Is there any examples in the manual you would recommend me to look at?

I really appreciate any help you guys can give me.
Thank you so much