Results 1 to 2 of 2

Thread: Plate-and-frame heat exchanger scenarios failure/relief capacity

  1. #1

    Thumbs up Plate-and-frame heat exchanger scenarios failure/relief capacity

    Dear all,

    Does anyone have some references or ideas about procedure for relief rates calcultaion for a Plate-and-Frame heat exchange; especially pinhole thru plates (the equivalent of tube rupture in shell-and-tube heat exchanger)...


    Thank you for sharing !


    See More: Plate-and-frame heat exchanger scenarios failure/relief capacity

  2. # ADS
    Spons Circuit
    Join Date
    Always
    Posts
    Many
     
  3. #2

    Re: Plate-and-frame heat exchanger scenarios failure/relief capacity

    You could use a 10mm hole through plate, but no clear references about it.

    Regards

    My threads; jasr76 :


    •    Sponsored Links



      -

    Similar Threads

    1. Replies: 0
      Last Post: 08-14-2013, 05:19 PM
    2. Heat Exchanger: Corrosion & Failure
      By ameer in forum Materials Science &Corrosion
      Replies: 3
      Last Post: 10-03-2011, 12:00 PM
    3. Article: Heat Exchanger: Corrosion & Failure
      By ameer in forum Home Articles
      Replies: 1
      Last Post: 07-20-2011, 06:28 AM
    4. Design of Washboard type plate Heat Exchanger
      By abc123 in forum Mechanical Engineering
      Replies: 1
      Last Post: 01-28-2010, 08:04 AM
    5. HYSYS and Plate Heat Exchanger
      By asozhyan in forum Process Simulation Community
      Replies: 0
      Last Post: 07-12-2009, 02:06 PM

    Tags for this Thread

    Bookmarks

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •