<

Results 1 to 2 of 2

Thread: Article: The relation between wind speed and min required purge rate to avoid flare s

  1. #1

    Article: The relation between wind speed and min required purge rate to avoid flare s

    You can view the page at

    [link Point to another website Only the registered members can access]


  2. # ADS
    Spons Circuit
    Join Date
    Always
    Posts
    Many
     
  3. #2

    Re: Article: The relation between wind speed and min required purge rate to avoid fla

    I've tried to contact the vendor but no response, but I've found the following:

    BP flare guidance Annex C states that "Note: It should be recognised that Husa correlation was derived under calm or no wind conditions and is generally applicable for wind speeds up to approximately 13,4 m/s (30 mph). Locations where prevailing winds can often exceed this wind speed may need somewhat higher purge rates.". to me this is fair enough.

    Regards
    Malek

  4.    Sponsored Links



    -

  •   

Similar Threads

  1. help me: FLARE PURGE GAS
    By barbara in forum Petroleum Club
    Replies: 23
    Last Post: 02-04-2017, 06:04 PM
  2. Article: purge gas to flare header
    By engmahmoudmaher in forum Home Articles
    Replies: 0
    Last Post: 03-25-2014, 10:58 AM
  3. Replies: 1
    Last Post: 02-04-2014, 02:28 PM
  4. Article: Purge Gas Rate
    By asade in forum Home Articles
    Replies: 1
    Last Post: 11-30-2012, 02:48 PM
  5. Purge Gas Rate
    By asade in forum Oil And Gas Process
    Replies: 0
    Last Post: 11-07-2012, 06:22 PM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •