Pipesim modeling

[MESSADAA]

Hi Guys !
I'm preparing my Graduation project with PIPESIM software (V.2009) ,I 'm still improving in PIPESIM tutorials but I'm not yet used to work on! I have a little problem in using units , when I run the model and I need to have a Flow rate volume basis(bbl\d),I can't found this unit in Ps PLot series ! How can I found this ?
Thank u for helping me !

[seel_20]

Just go to "Setup"=> "Units" => then select your unit. I think that "Eng" will fit with what you are looking for.
I hope it helps...

[seel_20]

Just go to "Setup"=> "Units" => then select your unit. I think that "Eng" will fit with what you are looking for.
I hope it helps...

[MESSADAA]

Just go to "Setup"=> "Units" => then select your unit. I think that "Eng" will fit with what you are looking for.
I hope it helps...

Thanks a lot for help , but <setup>unit>flow rate> didn't show the unit bbl\d even by scrolling ! only STB\d ,sm3\d ,sm3\s
what should I do ?
when I go to the <setup>unit>flow rate>custom >more unit > I can see the flow rate volume basis !!!
but how define this new unit ?