WRC107 Assistance Please in Reading Curves

[mikeyles]

I am looking at a external hollow round attachment on the spherical part or a Torisperical shaped top dished end and I was looking for assiatance in................. for example reading the correct curve given the geometric parameters ot T=32.6, p=1.0, U=1.45, say for the first point in Table 3. eg Nxt/P .

Thanks in advance

PS I Know most would use FEA software, but the jobs I get like this a few and far between and will be checkedby others using FEA.

[mikeyles]

Perhaps I should have explained further............... effectively the curves are labelled with the T and geometric parameters that I obviously not equal to what I have got have not got, and thus I am not sure which of the SP or SM curves I am to use.