Slug Catcher sizing

[padua]

Slug catcher sizing reference were taken from GPSA fyi.

PS. there is a good handbook on "Offshore hydrate engineering handbook"
just type in google to Scrib link.

signed.
padua

[anwarahmad]

Very much appreciated...

[CarlosBatista]

I have the spreadsheet for calculation of this equipment (process point view) if you need please send your e mail to jinbukan@yahoo.com with reference slug catcher

[praphulla.phirke]

Hi Carlos
Can you please mail me the spreadsheet?

Thanks & Regards
Praphulla
praphulla.dp@gmail.com

[praphulla.phirke]

Hi Carlos
Can you please mail me the spreadsheet?

Thanks & Regards
Praphulla
praphulla.dp@gmail.com

[akamal]

Kindly send me the sheet on following address:

ak_008@hotmail.com

[Frusso]

I have the spreadsheet for calculation of this equipment (process point view) if you need please send your e mail to jinbukan@yahoo.com with reference slug catcher

Could you send me a copy of the spreadsheet please at the following
frusso1953@gmail.com

Thanks
FR

[jayhuacat]

Hi Carlos,

can u send me the spread sheet of slug catcher design?

Thank you.

Jay

[ebyrich]

Hi Carlos
Can you please mail me the spreadsheet?

Regards
Ebyrich
ebyrich@yahoo.com

[Shahriar]

I need some help about critera on blow down and relief sizing of slug catchers(finger or vessel). I'm a safety engineer and I gotta use it for risk calculation.

[padua]

Shahriar,

Regards to your question:

I need some help about critera on blow down and relief sizing of slug catchers(finger or vessel). I'm an safety engineer and I gotta use it for risk calculation.

Ans: From my knowledge, the blowdown of any slug catcher is going to
be part of the compressors settle-out pressure calculation, so you would
include the volume of the gas from the slug catcher and up to the check
valve on the discharge of the compressor or up to the fail close valve located
on the discharge of the compressor.

From there please use Hysys simulation depressurization to determine your
blowdown flowrate to 6.9 bar @ 15 minutes accordingly to API 520 or 521.

Regards,
Padua.

[ait]

Hi Carlos
Can you please mail me the spreadsheet?

Thanks & Regards
Praphulla
khelifa.aitabdallah@gsa.dz