API STD 614 Lubrication, Shaft-Sealing, and Control-Oil Systems and Auxiliaries for Petroleum Chemical and Gas Industry Services
API publications necessarily address problems of a general nature. With respect to particular
circumstances, local, state, and federal laws and regulations should be reviewed.
API is not undertaking to meet the duties of employers, manufacturers, or suppliers to
warn and properly train and equip their employees, and others exposed, concerning health
and safety risks and precautions, nor undertaking their obligations under local, state, or federal
laws.
Information concerning safety and health risks and proper precautions with respect to particular
materials and conditions should be obtained from the employer, the manufacturer or
supplier of that material, or the material safety data sheet.
Nothing contained in any API publication is to be construed as granting any right, by
implication or otherwise, for the manufacture, sale, or use of any method, apparatus, or product
covered by letters patent. Neither should anything contained in the publication be construed
as insuring anyone against liability for infringement of letters patent.
Generally, API standards are reviewed and revised, reaffirmed, or withdrawn at least every
five years. Sometimes a one-time extension of up to two years will be added to this review
cycle. This publication will no longer be in effect five years after its publication date as an
operative API standard or, where an extension has been granted, upon republication. Status
of the publication can be ascertained from the API Downstream Segment [telephone (202)
682-8000]. A catalog of API publications and materials is published annually and updated
quarterly by API, 1220 L Street, N.W., Washington, D.C. 20005.
This document was produced under API standardization procedures that ensure appropriate
notification and participation in the developmental process and is designated as an API
standard. Questions concerning the interpretation of the content of this standard or comments
and questions concerning the procedures under which this standard was developed
should be directed in writing to the director of the Downstream Segment, American Petroleum
Institute, 1220 L Street, N.W., Washington, D.C. 20005. Requests for permission to
reproduce or translate all or any part of the material published herein should also be
addressed to the director.
API standards are published to facilitate the broad availability of proven, sound engineering
and operating practices. These standards are not intended to obviate the need for applying
sound engineering judgment regarding when and where these standards should be
utilized. The formulation and publication of API standards is not intended in any way to
inhibit anyone from using any other practices.
Any manufacturer marking equipment or materials in conformance with the marking
requirements of an API standard is solely responsible for complying with all the applicable
requirements of that standard. API does not represent, warrant, or guarantee that such products
do in fact conform to the applicable API standard.
All rights reserved. No part of this work may be reproduced, stored in a retrieval system, or
transmitted by any means, electronic, mechanical, photocopying, recording, or otherwise,
without prior written permission from the publisher. Contact the Publisher,
API Publishing Services, 1220 L Street, N.W., Washington, D.C. 20005.
Copyright © 1999 American Petroleum Institute
COPYRIGHT 2000 American Petroleum Institute
Information Handling Services, 2000
COPYRIGHT 2000 American Petroleum Institute
Information Handling Services, 2000
[link Point to another website Only the registered members can access]
Reply With Quote
Bookmarks