Flange leakage Calculation acc to Blick method

**tony_black** · 04-25-2010, 09:32 AM

Mariog, sorry I do not think that I have much in the way of compression setting of gaskets (nothing comes to mind right away anyway). Other than the general concept & testing to ASTM D395. I think one would have to specifically request indepth data from manufacturers, because usually all that is supplied is typically as per page C-21:

[link Point to another website Only the registered members can access]
Unless you can state a specific article I may have it, but otherwise I am just shooting in the dark in my library.

**mariog** · 04-25-2010, 05:05 PM

Dear Tony,
Thanks for your answer.
I've asked because Caesar II report has such calculation since within "Gasket Compression" section there is an "Leak-Proof Joint (Creq)".
When I've asked for clarification they said it is the required compression to prevent leakage.
But I haven't any reference.

**shankargee** · 04-30-2010, 07:26 PM

thanq lot

**shankargee** · 07-25-2010, 06:08 PM

thanq

**aarcela** · 03-23-2011, 08:08 PM

please reload it Thanks, the file doesn´t exist in "ifile.it".

**Bublimaddy** · 03-26-2011, 03:11 PM

please reload the article it is not available now!

Such classics we cannot get anywhere.

**luisbmwm6** · 11-30-2011, 07:06 PM

tony the link on dead please upload tnat again

**mariog** · 12-02-2011, 05:51 PM

[link Point to another website Only the registered members can access]
Thanks to tony_black.....

**mech.satish** · 04-11-2012, 07:14 PM

Dear Mr tony,

I am also looking for flange keakage document. I have followed the link. but it is showing no such file.

Please upload once again or forward to my mail id : mech.satish@gmail.com
Thanks and regards,
Satish