Help in Eclipse

[sofiane9500]

Dear reservoir engineers, I am begginer in Eclipse

When I run the simulation with production rate, I have this message ;

******************************************
@ * WELL P-12 HAS CHANGED TO *
@ * CONTROL BY BOTTOM HOLE PRESSURE *
@ * FROM TIME 181.00 DAYS . *
@ ******************************************

What's the problem and how I can resolved?

[REGI_MAX]

Sims your well PI (reservoir permeability) for the given fluid rates is not correct...
in case your fluid rates are correct, use WELPI or better WPIMULT in schedule section to resolve the problem

[REGI_MAX]

Sims your well PI (reservoir permeability) for the given fluid rates is not correct...
in case your fluid rates are correct, use WELPI or better WPIMULT in schedule section to resolve the problem

[vergatario]

the well can not produced at the rate given. you need to increase the permeability of your model. Also you may increase the porosity, in that way the reservoir pressure will drop slowly.















y

[i-anuar]

also depends on what BHP pressure you have as a constraint. did you specify it explicitly and it is too high? if it is defaulted and your actual data suggest that performance should be better then you may want to review (as suggested by others) rock props or well PI etc.