Iso 5167

[shankarmathur]

Hi Freinds

Does someone have a copy of ISO 5167 ?

Shankar Mathur

[Nabilia]

ISO 5167-1 Measurement of fluid flow by means of D.P. Meters - General principles & Requirements.pdf

[link Point to another website Only the registered members can access]
ISO 5167-2 Orifice plates.pdf

[link Point to another website Only the registered members can access]
ISO 5167-3 Nozzles and Venturi nozzles.pdf

[link Point to another website Only the registered members can access]
ISO 5167-4 Venturi Tubes.pdf

[link Point to another website Only the registered members can access]

[shankarmathur]

Many Thanks Nabilia

Shankar Mathur

[ehrashid]

Can u please advise what is the maximum allowable differential pressure across the orifice plate according to ISO 5167.

[Nabilia]

From ISO 5167-2
5.1.2.3 Care shall be taken in the design of the orifice plate and its installation to ensure that plastic buckling and elastic deformation of the plate, due to the magnitude of the differential pressure or of any other stress, do not cause the slope of the straight line defined in 5.1.3.1 to exceed 1 % under working conditions.
NOTE Further information is given in 8.1.1.3 of ISO/TR 9464:1998.

[Nabilia]

I found the 9464 for you.

BS ISO TR 9464-1998 - Guide to the use of ISO 5167-1-1991.pdf 5.676 MB

[link Point to another website Only the registered members can access]

[irfpat]

dear sir,

please upload again as its deleted.

[aabdulaslam@gmail.com]

ISO 5167

[link Point to another website Only the registered members can access]

[salmanisn]

please upload again

[dadara]

Dear,

are those links fuctioning at all, and also is there any good and easy to use software to be able to calculate based on all 4 pats of 5167.

[ilayarasan]

Please upload again.....Link not working

[aabdulaslam@gmail.com]

[link Point to another website Only the registered members can access]