Dear Sir
Any one know about keyword "SWATINIT" (Initial water saturations for capillary pressure scaling).
Below there is how the keyword is prepared in the notepad (The value of SWATINIT are -), and I can run it without any error.
The problem is that when I import this set of data to office, many errors appear (NEGATIVE VALUE -0.200 ENTERED FOR BLOCK ( 9, 1, 2) OF KEYWORD SWATINIT )
It said that SWATINIT cannot be minus. Why I can not run it with office while I can run it normally with Eclipse. ?

--
-- -- ARRAY CONSTANT -- ---------- BOX ---------
-- I1 I2 J1 J2 K1 K2
ADD
'SWCR' 0.2000 1* 1* 1* 1* 2 2 / INCREASE Swc TO SLOW DOWN WATER BREAKTROUGH IN WELL SA-01
'SWATINIT' -0.2000 1* 1* 1* 1* 2 2 /
'SWCR' 0.1000 1* 1* 1* 1* 22 23 / INCREASE Swc TO SLOW DOWN WATER BREAKTROUGH IN WELL SA-01
'SWATINIT' -0.1000 1* 1* 1* 1* 22 23 /
'SWCR' 0.1000 1* 1* 1* 1* 53 58 / INCREASE Swc TO SLOW DOWN WATER BREAKTROUGH IN WELL SA-12ST
'SWATINIT' -0.1000 1* 1* 1* 1* 53 58 /
'SWCR' 0.0300 28 33 33 47 10 18 / INCREASE Swc TO SLOW DOWN WATER BREAKTROUGH IN WELL SA-08
'SWATINIT' -0.0300 28 33 33 47 10 18 /
'SWCR' -0.1000 33 37 41 50 27 29 / INCREASE Swc TO SLOW DOWN WATER BREAKTROUGH IN WELL SA-09
'SWATINIT' 0.1000 33 37 41 50 27 29 /
/

Thanks