pipeline anchor block calculation

[er_scec]

thank you ...
during pipeline construction, in the engineering, it's request when a pipeline connect with afcility, we put an anchor block..
we have all informations about this :
pressure,température , diameter, material, soil density, coef of friction of the sol..etc...
the dimensiosn of the block are not the same ( wter lines, oil lines and gas lines)
I am sur that the design is the same but tehe results depend from temperature and pressure of pipe...
can you have me this formula , or any book design...
regards

Hi again, casually I did some time ago a calculation for anchor blocks, it hasn't been validated yet but the results seem logical. Send me your e-mail for share it.

Regards,

Eddie