HTRI v 5 SP2 or v 6 Required

[karimo]

i already got the manual but still confused.. the fils are expired... if u get the training slides plzz share it ...thks

[henj]

Another good book partly based on HTRI is Hewitt book: Practical Thermal Design Of Shell-and-tube Heat Exchangers

[link Point to another website Only the registered members can access]

[karimo]

thks a lot henj

[henj]

the fils are expired... if u get the training slides plzz share it ...thks

The link for the book of Serth in post #60 has been change for a working one.
I have so far only found the slides as my prints on paper..
Anyone remember the links?

[aseptman]

pl sahre the xist dlls

[henj]

pl sahre the xist dlls

For HTRI 5 you have them posted in

[link Point to another website Only the registered members can access] as "Unrar_in_XS5.rar" files

You also may need these for version 6 together with the original dlls. See post #50 and #55 in this thread.

[aseptman]

Thanks Henj,
But 5 dll's do not seem to work for 6. Ace in 6 thus works but not the others like XIST/FH/PHE etc.

[henj]

But 5 dll's do not seem to work for 6. Ace in 6 thus works but not the others like XIST/FH/PHE etc.

Okay. Then HTRI 6 is okay in Ace, you need to copy the original dlls and the Cr***ed from version 5 to all other folders than Ace-folder, say the Xist folder.
Do as mentioned in post #55 and follows in this thread.

Hope this help you :-)

[aseptman]

Henj,
I tried the following:
Replaced the dlls in ver6 with V5 dll (like desn,rate,aspenrate) also there is one setplanst thing which is diff in 6 and 5. That was also changed plus some additional dll in 5 ver like input/output/execute...but then if u open some expmples it runs for a while but a slight change in any parameter and u get run failed error.
I think forget the 6. also 6 has only ace and ist no phe/fh or others do u know any link where u get the full one?
But thanks it almost worked

[tank]

Does anybody have the Xist ******** of the HTRI 6?
I tried to c**y the dll files of the V5, to V6 it works but do not copy the rate.dll
But then when i tried for Xist with VMG databank it cannot work, somebody help please..

Other question is anybody have the complete data bank of HTRI?

[ql007829]

Hi, Henj!
Thanks a lot ! I also found after CR with ******** of V5, iXist screen of V6 showed a V5 version signal. Is that Ok?

[henj]

I also found after CR with ******** of V5, iXist screen of V6 showed a V5 version signal. Is that Ok?

Yes, That is as it is.
You still have access to some of the new things. There is needed a "full" ******** which is not around.