My well does not produce (Eclipse)

[guanyu4u]

Hi all..

I'm trying to run a simulation for my oil-water model on Eclipse. After I draw my grid and filled my data, I operate RUN and there were some warnings saying that the well pressure is too low to produce. When I tried to check RESULT, the oil in place is constant and there is no production.

I believe the problem is in the schedule but I don't know where exactly. Can anybody help? I just want to get the well to produce for about 4-6 years even if parameters like prod. rate and adding an injecting well had been added.

This is my model

[link Point to another website Only the registered members can access] The schedule section in the attachment.

[link Point to another website Only the registered members can access]