High Pressure Pumps

ECH1

Published on 01-23-2015 06:11 AM

3 Comments

Dear Colleagues,
I'm analyzing some pumping equipment to work at very high pressure.
The operating pressure of these equipments is 5000 psi (350 Kg / cm2).
As are very low flow pumps 74 GPM (400 m3 / d) and I'm analyzing equipment as REDA, Centrilift and GE (former Woodgroup), all them operated by VFD, I wanted some advice from you.
Regards.
Eduardo.

_{This article was originally published in forum thread:

High Pressure Pumps
started by
ECH1} _{View original post}

3 Comments

rogman - 01-26-2015, 05:11 PM
- Reply
I know about plunger pumps brand Uraca: [link Point to another website Only the registered members can access] We didn't rise more than 3000 psi but there are pumps of higher pressure levels in that brand. Our pump didn't operate with a VFD.
Check it.

rogman - 01-26-2015, 05:11 PM

Reply

I know about plunger pumps brand Uraca: [link Point to another website Only the registered members can access] We didn't rise more than 3000 psi but there are pumps of higher pressure levels in that brand. Our pump didn't operate with a VFD.
Check it.

GeraldFup - 06-07-2015, 09:10 AM

Reply

The new command CLOSEALLOTHER will close all open files except the one that is current.
[link Point to another website Only the registered members can access] Saya ingin melakukan stakeout alignment ini ke lapangan.

[link Point to another website Only the registered members can access] In this case, the minor radius must be 24, because the minor axis measures 48.

[link Point to another website Only the registered members can access] I will attempt to fix myself tomorrow.

[link Point to another website Only the registered members can access] This would be compatible with both 32 bit and 64 bit windows.

[link Point to another website Only the registered members can access]

vBulletin Message

Cancel Changes

Forum Categories

.

High Pressure Pumps

vBulletin Message

.

Recent Threads

Need to iso 15551 standard

Random Threads

.

..