<

View RSS Feed

manoj.chauragade

  1. CADworx Fieldpipe- Found error while selecting Metric Units

    by
    manoj.chauragade
    , 08-28-2013 at 12:29 PM
    CADWorx fieldPipe working fine when selecting Imperial Unit,

    But while selecting metric unit It will show error.. Diameter 5.40 was not found in spec $s***

    Please provide the solution.
    Categories
    Uncategorized
    Comments 0 Comments
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40