FATHI

is this based on API 510 ?
I am also interested
thanks

Originally Posted by Thaksen79

Dear Members,

I would like to know what are the acceptable ways to perform reinforcement calculation on a flat plate for an ASME Sec VIII Div-1 stamp Air Cooled Heat Exchanger. The nozzles sizes are 4" and 8". The flat plate thickness shall be min 10mm.

Consider the case of Designing an Air Cooled Heat Exchanger. The design parameters are as follows,
Shell side
Design Press Int/ext=1.03/FV barg
Design Temp Int/ext=150/150 deg Celsius
MDMT= -5
Corrosion Allow = 0mm

Tube side
Design Press Int/ext=0.6/FV barg
Design Temp Int/ext=90/150 deg Celsius
MDMT= -5
Corrosion Allow = 0mm

The Nozzle sizes approx 4" Outlet and 8" Inlet which are welded to flat plates.

For more details of the exchanger construction please visit the below link
https://www.dropbox.com/s/jxat77b0a5...anger.pdf?dl=0

Tags: ... thanks for posting

Categories

Uncategorized

Originally Posted by brom

can anybody share shell expro internal training manuals for mechanical electrical or instrument ?

I am also interested..thanks for sharing

Originally Posted by endorphin

Good morning,

I am looking for drawings of Metallic double-deck internal floating roofs. I can't find any information except for what is mentioned in the API 650 annex H.
We need to setup drawings for an existing steel tank with diameter of 82m1 and 23m1 high.

If any one has example drawings please share.
Thanks

I am also interested in this topic too..thanks to share

Originally Posted by raj_01

Friends,
Please share KBR Vessel Mechanical Desk Manual & KBR Vessel Mechanical Procedures.

Thank You in advance.

I am also interested in this standard.

By the way and this another topic, the book "Pressure vessel design" by Moses , 4th edition is a good one..
I believe it was posted on this site

Originally Posted by blankz

Dear All,

Did anyone have the newest pipeline toolbox software?
Share please...

I try to find about "Pipeline toolbox 2013 enterprise"
Please help...

Thanks.

thanks

Originally Posted by Minfo

Hi
I need installation source of CAESAR II 2014.
if anybody help me for it, maybe i could help you for ....

Thanks

I have this software ..But I do not know how to install it..just for personal use..

Originally Posted by liemngo

Can anybody helps?

kind of you ..thanks

Originally Posted by Thaksen79

Dear Friends,

I am looking for calculation made for API 650, 620 field erected tank roofs in staad pro. If possible could some one uploads the same. I would like to know the concepts also so if somebody can upload a video showing the calculation made in staad, it would be very helpful.

Thanks in advance...

thanks for bringing the subject.

It is known that software such Tank or Etank are not meant for calculation of supported roofs.

One should also note that the load combinations to be considered is given in API 650

Originally Posted by JOEBOULDER

Hi brothers! I appreciate so much if anyone has a suscription of this mag for share with people interesting in Aboveground and Underground Storage Tanks for liquids (crude oil, refinery products, petrochemicals and biofuels mainly ethanol and methanol). Best regards from Venezuela.
joeboulder