I have defined CaCl2Brine properties as Hypo component (these were taken from DIPPR)

The purpose was to have an x3 effect evaporation unit; so I had Duhring chart to know that at what temperature; mixture of a specified w.t% CaCl2 will boil.

This binary plot was constructed using HYSYS (w.t%)

[link Point to another website Only the registered members can access]
If you compare this with following Duhring plot

[link Point to another website Only the registered members can access]
My PFD (using NRTL no BIPs)

[link Point to another website Only the registered members can access]
You will see that HYSYS under-predicts BPE. For instance if my last effect is going to achieve 60w.t% of CaCl2 solution the temperature of that separator per Duhring is to be ~160C (ACTUALLY IT IS) but HYSYS predicts ~135C

My question is what property while defining Hypo effects this behaviour? How can I make binary plot somewhat closer to Duhring plot?


See More: How does HYSYS calculate Boiling Point Elevation