SAMSUNG Standards for Piping Design

[zytron]

thanks nice
sweet

[flex]

Thank you a lot!

[AnandV]

Thanks a lot

[jcrv]

Thanks a lot

[prashant.10]

thank you for your support sir!!!

[donald]

thank sir , for sharing this document. it is very very much usefull .

[victorlachica]

Thank you

1. Piping Design Manual - Underground (0.766 MB):

[link Point to another website Only the registered members can access] 2. Piping Design Manual - Rack Piping (0.622 MB):

[link Point to another website Only the registered members can access] 3. Compressor and Turbine Piping Design Standard (0.548 MB):

[link Point to another website Only the registered members can access] 4. Piping Design Manual - Pump Piping (0.232 MB):

[link Point to another website Only the registered members can access] 5. Piping Design Standard around Fired Heater (0.366 MB):

[link Point to another website Only the registered members can access] 6. Vessel & Drum Piping Design Standard (0.743 MB):

[link Point to another website Only the registered members can access] 7. Piping Design Manual - Tankyard Piping (0.225 MB):

[link Point to another website Only the registered members can access] .

[Abdel Halim Galala]

Two additional SAMSUNG files:
9. SAMSUNG Flow Chart of Countermeasures for Vibration Caused by Slug Flow:

[link Point to another website Only the registered members can access] 10. httpSAMSUNG Storage Tank Farm Piping:http:

[link Point to another website Only the registered members can access]

[Abdel Halim Galala]

The same SAMSUNG files:
9.

[link Point to another website Only the registered members can access] 10.

[link Point to another website Only the registered members can access]

[suchart]

thank

[maskedsperm]

Mr. Abdel Halim Galala,

Thanks again for sharing such a wonderful information with us, but, once I extracted the files I noticed there are some incomplete pages. The incomplete pages are as follows:

Piping Design Manual (Underground)

Apendix III - Hydraulic Table (Sht.64 to sht.68)
Apendix IV - Q {l/sec} : V {m/sec} (Sht.70 to sht.76)


Vessel & Drum Piping Design Standard

Apendix I - Veseel Orientation / Elevation (Sht.20)
Apendix XI - Access requirements for Vessels (Sht.30)
Apendix XIII - Layout / Min Platform Width Req for Manholes (Sht.32)
Apendix XV - Platform / Nozzles Clearances and Projections (Sht.34)
Apendix XVII - Davits (Sht.36)


Piping Design Manual (Piperack)

Apendix I - Sample of Piperack loading data information dwg (Sht.47)
Apendix II - Sample of Calculation Table for Max Bending Stress, Anchor force and friction force (Sht.48)

Would you pleas be so kind in uploading these pages again (corrected)? or send them to my e-mail address (vaso_e_agua@yahoo.com)?

Thanks in advance

Nothing.... so far....

[PUNLOP]

Thank you vary much