Caesar II

[javad64]

Hello
I have a problem with module in software Caesar II version 4.5
If we have pipeline (line 1) that it is start from other line ( or we want analyse pipeline that branch from source line (line 2) and connect to other pipeline )
I module line 1 but I don’t know in fist and end of line who to module it at first node (node 5) from line 1 (node 5 is center of tee that line1 start from this node )
In this node who can module displacement and support ? because I don’t have any information from line 2 and it is very difficult to module source line
Thank you very much

[hermes]

Dear Javad64:
I guess (I believe) you have no trouble with caesarII.
You have some missunderstanding with your client.
It is responsibility of the owner to provide to the designer all the data, as "certified design data set".
You have to get from the owner all certified design data related to the points (nodes) where you work (the pipeline you are working on) begins and ends.
Hope it will help you. Regards.

[galant1960]

can you send me the iso , I can help you...your caesar is original? I work with company and we have caesar 5.2...but I want to have cesar with we...i dowload many times but never working...
in your exemple, it's difficult to undestand without drawing..send it to me.
ragards