Prosper problem

[Omegapiratemex]

Hi, i have a problem with the simulation of a well in the prosper software, in the analysis summary(system section), im trying to make an analysis of the actual conditions of a well. When i try to simulate the conditions in the outlet (pipeline) the VLP curve remain the same value for all the rate points. The IPR curve also shows a strange behavior with all the vertical lift correlations. I attached a picture to better explain the problem.

[link Point to another website Only the registered members can access]
I hope some of you can help me.

Regards

DAIH

[petroengfas]

Hello DAIH

You should change "Solution node"

[mausi]

Change the solution node to the bottom node. Right now the solution node is set to the top node which has a fixed pressure of 26.9 Kg/cm2. That's why the VLP is a flat line.