Boiling Fluids - Recommended Suction Flow Velocity

[Esam]

Capacity problem, cavitation and high power consumption in a pump, is often the result of the conditions on the suction side. In general - a rule of thumb - is to keep the suction fluid flow speed below the following values:

Pipe bore		Boiling Liquids
inches	mm	m/s	ft/s
1	25	0.3	1
2	50	0.3	1
3	75	0.3	1
4	100	0.3	1
6	150	0.35	1.1
8	200	0.38	1.2
10	250	0.45	1.5
12	300	0.45	1.5

Boiling liquids - due to the cavitation problem - may be extremely difficult to pump. If the pressure at any point within the pump falls below the vapor pressure of the liquid being pumped, vaporization or cavitation will occur. For example, water at 100^oF (38^oC) boils or vaporizes if exposed to a vacuum of 28 in Hg. The problem with cavitation increases with higher temperature.
More about boiling water or condensate pumping in steam systems can be read here:

• Condensate Pumping The challenge with pumping condensate with high temperature and cavitations of pump wheels.
• Steam Systems and Feeding Pumps Suction Lift

More about NPSH suction problems can be read here:

• Cavitations and NPSH An introduction to cavitations and Net Positive Suction Head, NPSH

[amitss_sam]

Esam thanks, but how u derived those velocities? I feel that these values must be doubled which u have given.

Waiting to hear from u.