AGA Purging Principles and Practices

[mhenna]

AGA XK0101

This publication provides guidelines for maintaining safe atmospheres inside pipes, holders, and other facilities that are to be purged into service or taken out of service. Purging data for inlet control pressures has been expanded from 15miles/34 inch pipe in the old table to 50 miles/48 inch pipe in the new table, through GRI (now GTI) funded research. Potential purging with CO2 is emphasized. The chapters on LP Gas facilities and Gas Analysis and Instrumentation also were updated.

The link :

[link Point to another website Only the registered members can access]

[npsrinivasarao]

Dear mhenna,
The link does not open.

[Nabilia]

AGA-XK0101 Purging Principles and Practice 3rd Ed. 2001.pdf 20.145 MB

[link Point to another website Only the registered members can access]

[npsrinivasarao]

Dear Nabilia,

Thanks again. I was desperately looking for some info on this subject and you are really a saviour. Kindly share any further info on this subject. Including procedures, Formats and Method statements if available. Thanks in advance.

[nayakya]

Dear Nabilia,

Thanks

[greges2009]

Nabilia thank you

[AfigueredoU]

using that information i have made some calculations:

[link Point to another website Only the registered members can access]

[nghiah5]

Dear,
Link is died ready. Please re-fix it.
Thank Nabilia and all

[mhenna]

the link is ok!

[link Point to another website Only the registered members can access]

[nghiah5]

Thank mhenna so much.
I downloaded it, and link is good
Thank mhena again.

[philrod_52]

anybody can share with me the Purging Procedure (Storgae Tank) Crude Oil. Thank you so much

[mej]

Here is a working link for AGA Purging Principles and Practice:

[link Point to another website Only the registered members can access]



Here is a link to a general presentation on fuel gas piping cleaning and purging, which may also be of interest:

[link Point to another website Only the registered members can access]