I would like to know what are the acceptable ways to perform reinforcement calculation on a flat plate for an ASME Sec VIII Div-1 stamp Air Cooled Heat Exchanger. The nozzles sizes are 4" and 8". The flat plate thickness shall be min 10mm.
Consider the case of Designing an Air Cooled Heat Exchanger. The design parameters are as follows*
Design Press Int/ext=1.03/FV barg
Design Temp Int/ext=150/150 deg Celsius
Corrosion Allow = 0mm
I am looking for drawings of Metallic double-deck internal floating roofs. I can't find any information except for what is mentioned in the API 650 annex H.
We need to setup drawings for an existing steel tank with diameter of 82m1 and 23m1 high.
If any one has example drawings please share.
I am also interested in this topic too..thanks to share