I have simple synthetic model, and I'm simulating injection scheme that varies based on a function. Instead of a constant injection rate as shown below, I want it to change according to some fuction. How can I implement this in Eclispe. Thanks

WCONINJE

INJ WATER 1* RATE 10000 10000 400 /

/

WCONPROD

PRD 1* LRAT 1* 1* 1* 10000 1* 250 /

]]>WCONINJE

INJ WATER 1* RATE 10000 10000 400 /

/

WCONPROD

PRD 1* LRAT 1* 1* 1* 10000 1* 250 /

I would like to find an informative material based on multiple real cases analyses that will show typical uncertainty ranges for estimating reserves during different stages of field life like Discovery, Appraisal, Development, Plateau, Decline for different Hydrocarbon reservoirs. The real cumulative is available after field is abandoned but how is this number vs initial P10-P50-P90 estimation?

This of course, depend a lot on amount of the data you have. As example if you made a discovery with a good quality 3D seismic, excellent logs and downhole fluid samples, good analogs then you expect to start with a smaller P10/P90 range (like P10/P90 ~ 2.5) than in a field where you have only some 2D seismic lines, fewer logs, surface sampling and so on (here initial P10/P90 ~ 5). Of course my numbers are just examples. Any thoughts?

]]>This of course, depend a lot on amount of the data you have. As example if you made a discovery with a good quality 3D seismic, excellent logs and downhole fluid samples, good analogs then you expect to start with a smaller P10/P90 range (like P10/P90 ~ 2.5) than in a field where you have only some 2D seismic lines, fewer logs, surface sampling and so on (here initial P10/P90 ~ 5). Of course my numbers are just examples. Any thoughts?

Hi everyone, I'm new to the forum and to reservoir simulation, I'm currently learning the basics of Eclipse and I'm wondering if Eclipse can simulate pH-sensitive microgels? I only read about BrightWater from the manual. Please advise if it's possible and how?

]]>how can i get C and n factors for a gas well IPR modeling ,

i have 3 rate tests with wellhead pressure and CGR , WGR ?

]]>i have 3 rate tests with wellhead pressure and CGR , WGR ?

I need the solutions manual for this book:

"Solution Manual Tarek Ahmed Reservoir Engineering Handbook, 4th ed 2010"

Thank you

]]>"Solution Manual Tarek Ahmed Reservoir Engineering Handbook, 4th ed 2010"

Thank you